Dandy Campers

Dandy Trailer Tent / Folding Camper Enthusiasts. Dandy Trailer Tent/Folding camper the best for all year camping


New foam and covers

Share
avatar
bedwok

Posts : 53
Join date : 2012-12-19
Location : warwickshire

New foam and covers

Post by bedwok on Thu 03 Oct 2013, 10:11 pm

I am looking to replace all the foam and covers in my designer and after a few hours scouring the net i am non the wiser really. Couple of questions if anyone can help. Firstly to save me the time going to the storage and putting the dandy up does anyone have the rough dimensions of all the foam i will need just so i can get a ball park idea of costs.......i realize i will have to get accurate measurements before going ahead with anything ! Also has anyone had this done and therefore recommend a supplier (or one to avoid as the case maybe) that i could contact for a quote. Any help/ideas/advice would be greatly appreciated.

navver

Posts : 1005
Join date : 2013-01-03

Re: New foam and covers

Post by navver on Thu 03 Oct 2013, 10:41 pm

Guestimating roughly,

The bed sizes are approx 6ft 4in long by 3ft 10 wide. One is split into two pieces each approx 2 ft wide.
The single bed is 6ft 4 long by 2ft wide divided into 4 pieces each about 1ft 7in x 2ft.

Thickness is about 3 inches.

I would measure first and again before cutting though.
avatar
Caz1960

Posts : 1716
Join date : 2011-09-04
Age : 58
Location : Cardigan west wales

Re: New foam and covers

Post by Caz1960 on Mon 07 Oct 2013, 11:48 pm

these are the best prices I have seen as foam is very expensive

[You must be registered and logged in to see this link.]
avatar
bedwok

Posts : 53
Join date : 2012-12-19
Location : warwickshire

Re: New foam and covers

Post by bedwok on Tue 15 Oct 2013, 9:05 pm

Thanks for that info navver saves me putting up Sandy (the dandy) in the rain and wind. I will be hoping to get the foam cut for me but will make sure i measure very carefully. Thanks caz1960 too.....that is cheap ! I missed that 1 when i was scouring ebay
avatar
mike
Dandy Owner

Posts : 5172
Join date : 2011-06-12
Age : 70
Location : north east lincs

Re: New foam and covers

Post by mike on Wed 16 Oct 2013, 2:53 am

As this will be be a once only job it may be worth researching foam density a little.the mattress is only thin and you don't want full compression when your on it.

mike

Sponsored content

Re: New foam and covers

Post by Sponsored content


    Current date/time is Mon 21 Jan 2019, 9:40 am